|
Usuarios conectados
Actualmente hay 5777 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
GETTING STARTED
CLOCK
BONUS
LANG
9 10
F.ADV
CLR/RST
Press the � or �button to select MFT. This is useful when the channel scanned is not clear. Press ¥ or � button to adjust for clear signal reception. Press the � or � button untill NAME is selected. The station name is set automatically from the broadcast signal. To change the programme�s name, press the � button. Result : The first letter of the name flashes.
F.ADV
CLR/RST
INSTALLATION
�� ¥� OK
END: MENU
11 12
3 4
Press the OK button to select this option. Press the � or � buttons to select MANUAL SET UP option.
AUTO SET UP MANUAL SET UP NEXTVIEWLINK SETTING SATELLITE SETTING VCR OUTPUT CH :CH36 �� �
INSTALL
To... Select a character in the name Move to the next or previous character
Then... o Press the � or � button until the required character is displayed. (letter, numbers or �-� character). o Press the ¥ or � button respectively, Then... o Press the corresponding � or � button, until the MFT is selected. o Press the ¥ or � button to adjust the picture, if necessary. o Press OK to store the station. o Press the corresponding � or � button, until the CH is selected. o Press the ¥ or � button to go on scanning the frequency band and display the next station. o Go back to the beginning of step 14
CURSOR
END: MENU
5
Press the � buttons to select this option. Result : The TV STATION TABLE menu is displayed.
** TV STATION TABLE **
PR 1 2 3 4 5 CH 002 NAME ----
CURSOR
13
OK
If you... Wish to store the stations displayed
�� �
OK
AUDIO
DELETE: CLR/RST
SWAPPING: OK MENU
Plus+
Do not wish to store the station displayed
AUDIO
Plus+
6 7
Press the � or � button to select a programme number as required. Press the � button to preset the station. Result : The MANUAL TUNING menu is displayed.
** MANUAL TUNING **
PR CH MFT NAME : : : : 1 004 ----
14 15
Repeat this procedure from step 6 onward, until all the required stations have been stored. On completion, press the MENU button three times to exit the menu. Note: RF output channel of the satellite receiver should be adjusted away from channel 60, which is used by the VTR.
�� ¥�
MEMORY: OK END: MENU
8 9
Press the button to start scanning until the RF OUT channel of the satellite receiver is displayed. Press the OK button to store the station, and then press the MENU button three times to exit the menu.
18
19
GETTING STARTED
2-8 Toshiba
66
Reference Information
GETTING STARTED
66
GETTING STARTED
Installation continued
Presetting the stations manually
Installation continued
When the RF connection on the satellite receiver connection page has been performed, the following settings must be carried out in order to activate satellite control. These settings are not necessary when the 21-pin SCART cable has been used for the connection. (see page 10)
Satellite Tuning
Press ¥ or � button to start scanning. Result : The frequency band is scanned and the first station found is displayed. If you know the number of the channel you want, press the numeric buttons on the remote control for example, for channel E21, first press �0� and then press �2�, �1� (see page 60).
8
1 2
Press MENU on the remote control. Result : The programming menu is displayed. Press the corresponding �, � or ¥, � buttons to select the INSTALLATION option.
PROG
OPTIONS
INSTALL
|
|
|
> |
|