GFM V07DVDVCR
Manual de Servicio

FIRMWARE RENEWAL MODE
1. Turn the power on and remove the disc on the tray. 2. To put the DVD player into version up mode, press [DVD], [9], [8], [7], [6], and [SEARCH MODE] buttons on the remote control unit in that order. The tray will open automatically. Fig. a appears on the screen.
"*******" differs depending on the models. "*******" differs depending on the models.

F/W Version Up Mode VERSION : Completed SUM : 7ABC

Model No : ******* VERSION : *.** ************.***

F/W Version Up Mode

Model No : ******* VERSION : *.**

Please insert a DISC for F/W Version Up.

Fig. e Completed Program Mode Screen

At this time, no button is available. 6. Remove the disc on the tray.
EXIT: POWER

7. Unplug the AC cord from the AC outlet. Then plug it again. 8. Turn the power on by pressing the [POWER] button and the tray will close. 9. Press [1], [2], [3], [4], and [DISPLAY] buttons on the remote control unit in that order. Fig. g appears on the screen.
"*******" differs depending on the models.

Fig. a Version Up Mode Screen

The DVD player can also enter the version up mode with the tray open. In this case, Fig. a will be shown on the screen while the tray is open. 3. Load the disc for version up. 4. The DVD player enters the F/W version up mode automatically. Fig. c appears on the screen. If you enter the F/W for different models, �Disc Error� will appear on the screen, then the tray will open automatically.
"*******" differs depending on the models.

MODEL : ******* Version : *.** Region : *

F/W Version Up Mode VERSION : Reading...

Model No : ******* VERSION : *.** ************.***

EEPROM CLEAR : CLEAR

EXIT: POWER

(*1)

Fig. g

10. Press [CLEAR/C.RESET] button on the remote control unit. Fig. h appears on the screen.
"*******" differs depending on the models.

Fig. c Programming Mode Screen

The appearance shown in (*1) of Fig. c is described as follows: No. 1 2 3 Appearance Reading... Erasing... State Sending files into the memory Erasing previous version data

MODEL : ******* Version : *.** Region : * EEPROM CLEAR : OK

EEPROM CLEAR : CLEAR

EXIT: POWER

Fig. h

Programming... Writing new version data

When �OK� appears on the screen, the factory default will be set. Then the firmware renewal mode is complete. 11. To exit this mode, press [POWER] button.

5. After programming is finished, the tray opens automatically. Fig. e appears on the screen.

1-9-1

E8E00FW