UX-V10GN
<Front panel assembly>
Prior to performing the following procedure, remove the rear cover, the side panels, the cassette mechanism assembly, the main board and the front panel assembly.
M
CD mechanism cover (CD mechanism assembly)
Removing the CD mechanism assembly (See Fig.18 to 21)
1. Disconnect the harness from connector CN721 and CN722, and the card wire from CN766 on the LCD board on the back of the front panel assembly.
CN766
R M
Belt Loading motor
M
CN721 LCD board CN722
2. Remove the five screws M attaching the CD mechanism cover to the front panel. Remove the CD mechanism cover together with the CD mechanism assembly. 3. Release the harness from each hook on the CD mechanism cover. 4. Remove the five screws N attaching the CD mechanism cover and the CD mechanism case. Release the three joints g of the CD mechanism cover and the CD mechanism case by pushing the joint hooks inward. 5. Disconnect the card wire from connector CN603 and the harness from CN605 on the CD servo control board. 6. Remove the CD mechanism assembly from the CD mechanism cover by pulling out it from the three bosses h.
Joint g
Fig.18
N
Joint g
N
CD mechanism cover
Loading motor CD mechanism case
N
Joint g
Removing the LED board (A) (See Fig.21)
1. Remove the screw O attaching the LED board (A).
N
Fig.19
CD mechanism cover
CD servo control board
LCD board (A) CD mechanism case Joint g CN603 CN605 CD mechanism cover
