JVC UX-S77UB
Manual de Usuario

To assemble and connect the AM loop antenna
To assemble the AM loop antenna

To connect the speaker cords
Connect the right speaker to the RIGHT terminals, and the left speaker to the LEFT terminals.
1 Open 2 Insert 3 Close

To connect the AM loop antenna
1 Hold 3 Release

When connecting the speaker cords, match the polarity of the speaker terminals: � For LOW terminals: Red cord to (+) and black cord to (�). � For HIGH terminals: Grey cord to (+) and blue cord to (�) The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers. � When placing the speakers near a TV set, turn off the TV�s main power switch or unplug it before installing the speakers. Then wait at least 30 minutes before turning on the TV�s main power switch again. Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV. � DO NOT connect more than one speaker to each terminal. � DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System.

2 Insert

� If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. � Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor reception.

6