3.1.7 Removing the main board (See Fig.19 and 20) � Prior to performing the following procedures, remove the rear cover. � Also remove the CD chassis assembly. � Also remove the bottom base assembly. (1) Disengage the wire M and then disconnect the parallel wire from the connectors CN902 (See Fig.20). (2) Removing the screw N retaining the main board onto the bottom base.
Main board
Bottom base
N
Fig.19
M
Fig.20 3.1.8 Replacing the 3-pin regulator (See Fig.21) � Prior to performing the following procedures, remove the rear cover. � Also remove the CD chassis assembly. � Also remove the main board assembly. (1) Remove the two screws P retaining 3-pin regulator. (2) Remove the solder fixing the 3-pin regulator Q216, .