SHARP UX-385
Manual de Servicio

4Remove the used film from the cartridge.

9Cut the band that holds the two spools together. Unroll the film slightly
and insert the small gears into their holders.

UX-385DE/H/GG/IT/ES FO-785DE/IT/ES/NX-575IT

5Remove the four green gears from the used film.

DO NOT DISCARD THE FOUR GREEN GEARS!

FTurn the cartridge over, grasp the handle, and insert the cartridge
into the print compartment.

6Remove the new roll of imaging film from its packaging.
� Do not yet remove the band that holds the rolls together.

GRotate the large gear toward you until the film is taut.

7Insert the large gear into the green end of the empty spool. Make
sure the two protrusions on the large gear fit firmly into the slots in the end of the spool. Insert the remaining three gears into the spools, making sure the protrusion on each gear fits firmly into one of the slots in the end of each spool. � If needed, pull the spools apart slightly to allow the gears to fit (the band will stretch).
Protrusion Slot

HClose the print compartment cover (press down on both sides to make
sure it clicks into place), and then close the operation panel.

Click!

Large gear

ILoad paper in the paper tray and then press the following keys to
Note: Paper must be loaded before the film can be initialized. To load paper, see the following section, Loading Printing Paper.
FUNCTION
Display shows:

8Insert the large gear into the large holder on the imaging film cartridge
(make sure it clicks into place), and then insert the small gear on the other end of the spool into its holder.

initialize the film.

6

INITIALIZE FILM
START/MEMORY

When to replace the imaging film Replace the imaging film when the display shows: FILM END Use the following imaging film, which is available from your dealer or retailer: Sharp UX-3CR/FO-3CR Imaging Film

1�5