1Rotate the original document support so that it points straight out.
3Unwrap the roll of fax paper and place it in the compartment.
�
Important: The roll must be placed so that the leading edge of the paper unrolls as shown. (The paper is only coated on one side for printing. If the roll is placed backwards, the paper will come out blank after printing.) NO!
YES
4. Loading the fax paper
� � Your fax machine prints incoming faxes on a special kind of paper called thermal paper. The fax�s print head creates text and images by applying heat to the thermal paper.
1Pull the release marked PANEL RELEASE toward you and open the
operation panel.
Note: The power must be on (plug in the power cord) when loading fax paper in the fax machine.
4 Insert the leading edge of the paper into the paper inlet. Continue to
Paper inlet
push the paper through the inlet until it comes out of the opening in the front of the fax.
2Remove the packing paper from the paper compartment.
Remove cardboard and tape
The paper will reappear here. Make sure it is aligned between the arrows on each side of the guide, and then passes under the plate and out the front of the fax.
5Close the operation panel, making sure it clicks into place.
Press here to close
2
Click!
1
6A short length of the fax paper will feed out and be cut off. (If this
doesn�t happen, repeat the loading procedure.) Note: The fax has a built-in anti-curl mechanism that will help to reduce paper curling problems. The anti-curl mechanism is more effective at the beginning of the paper roll and less effective towards the end.