How to move the chassis into the Service position
NOTE: To place the chassis into the advised service position the T.V. must be on the T.V. stand provided with the set.
1.
To place the chassis into service position hold and lift the rear of the E-PCB chassis and gently pull the chassis toward you as shown in Fig.5.
B-PCB service position.
i. ii. iii.
Release the respective wiring clips and rotate the chassis horizontally through anti-clockwise, then lift the front of the chassis as shown in 90_ Fig.6. Insert the beadclamper located in the bottom left hand corner of the cabinet (Fig.8.) into the chassis frame shown in Fig.9. After servicing ensure all wiring is returned to its original position before returning the receiver to the customer.
E-PCB service position.
i. ii. iii.
Release the respective wiring clips and rotate the chassis horizontally through 180_ anti-clockwise, the lift the FBT side of the chassis as shown in Fig.7. Insert the beadclamper located in the bottom left hand corner of the cabinet (Fig.8.) into the chassis frame shown in Fig.9 After servicing ensure all wiring is returned to its original position before returning the receiver to the customer.
