WHIRLPOOL TT14CKXAW01
Manual de Usuario

Using

the ice cube

trays

(TTIICK)

lf cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. To remove ice: 1. Hold tray at both ends. 2. Twist slightly.

Using

the optional

automatic

ice maker

lf you plan to add an automatic ice maker later (Part No. ECKMF-90) there are a few things you will want to know: l The aluminum water inlet tube, supplied with your refrigerator, is found in the rear, bottom of the refrigerator on the compressor support plate. This tube should be used instead of the tube provided in the accessory kit. . The ON/OFF lever is a wire signal arm. Down . . . to make ice automatically. up . . . to shut off the ice maker. ... NOTE: Do not turn to the
l

Rain signal arm to 8top ice.

signal arm to dart it

LOWW

of the

The dial or lever on the side of the ice maker changes the size of the cubes. l Shake the bin occasionally to keep cubes separated and to obtain increased storage capacity. l It is normal for ice crescents to be attached by a comer. They will break apart easily. l You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. l Because of new plumbing connections, the first ice may be discolored or off -flavored. Discard the first few batches of ice. l lf you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it in all the way and lower the signal arm to the ON position. . If cubes are stored too long, they may develop an off-flavor . . . like stale water. Throw them away. Ice maker will make new ice. Cubes in the ice bin can also become smaller by evaporation. 9