AEG TM 310 W
Manual de Usuario

Clean it with a brush and rinse it under the shower if necessary.

P0639

Also clean the outside, removing all fluff. Clean the rubber seal round the condenser cabinet and in the inner part of the small door with a damp cloth. Important! Do not use pointed objects or utensils to clean the spaces between the plates, as this could damage the condenser and make it permeable. Re-fit the condenser, turn the red stops upwards and close the door. Do not use this appliance if the condenser has not been fitted.

If this is not done a safety device trips: pilot light �full tank� on the control panel comes on. If you have just started the programme, after having emptied and re-inserted the reservoir, the machine can remain unactive up to 2 minutes before starting the programme again and during this period the light �full tank� remains alight. If the �full tank� light illuminates during the programme and you do not empty the reservoir immediately, the programme stops, leaving the laundry damp, but the drying time selector dial continues to turn towards the �O� position. After having emptied the container, you have to select the drying programme again for the time required to complete drying. The �full tank� light will stay on for approx. 2 minutes before the programme starts. Handy tip: The condensed water may be used in a steam iron or to top up a battery, etc. In this case it must be filtered (e.g. through a coffee filter).

Cleaning the air intake grille
Using a vacuum cleaner remove the fluff from the air intake grille at the back of the appliance.

Emptying the water reservoir
Water extracted from the laundry condenses inside the machine and is collected in a reservoir. The reservoir must be emptied after each drying cycle to ensure efficient operation when the machine is next used. Proceed as follows: � Pull out the reservoir � Turn it upside down and let water flow down � Re-fit the reservoir

P1162

P1156

P1157

The reservoir must be re-inserted correctly.

10