TOSHIBA TLP-X3000U
Manual de Servicio

Chapter 7

Projector Setup
Plug in the power cord; turn on main power switch and the power of the projector.

How to enter to the Factory Mode (TLP-X2500/XC2500/X3000/XC3000)
1) While the Volume adjustment bar is displayed on the screen, set value to [2], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 2) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 3) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 4) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously.
When the projector enters to the Service Mode, the buzzer beeps for 3 seconds. If doesn�t beep, repeat from the beginning. This mode maintains until you turn off the main power switch.

7-3