|
No hay comentarios de productos.
Turning the power off
Press the ON/STANDBY button.
Remote control Control panel
A message appears on the screen, confirming that you wish to shut off the power. This message will disappear after a moment. (This operation is no longer valid after the message disappears.)
Press the ON/STANDBY button again.
Remote control Control panel
The screen is turned off, but the internal cooling fan continues to operate for a short while. Then, the projector goes into standby mode.
Cooling in progress
ON LAMP TEMP FAN
(Orange) (Green) Flashing (Green)
During cooling, the LAMP indicator flashes. In this state, the power cannot be turned back on. In addition, unplugging the power cord in this state will shorten the life of the lamp. The LAMP and FAN indicators go off, and the projector goes into standby mode.
Cooling completed
ON LAMP TEMP FAN
(Orange) (Off) (Off)
Note
� The projector consumes about 1 W (AC 100 - 120 V) or 3 W (AC 220 - 240 V) of power in standby. You should unplug the power cord if you will not use the projector for an extended period.
PRECAUTIONS
� Before unplugging the power cord, make sure that the LAMP indicator is off. Unplugging the power cord to cut off the power while the projector is running or being cooled will shorten the life of the lamp. However, please unplug the power cord if the projector locks up or acts abnormally. � If the power cord was unplugged before cooling was completed, give the lamp sufficient time to cool down before plugging it back in. If the lamp overheats, it may fail to light, and its lifetime will be shortened. � Before turning the power off, turn down the volume if possible.
19
Others Maintenance Operations Preparations Before Using English
|
