TOSHIBA TDP-EX20
Manual de Usuario

Basic operations
1 Turn on the power.
Turn on the power by following the instructions in �Turning the power on� p.26 .

Notes
� When [Auto input search] is set to [Off] in the Default setting 1 menu p.43 (factory setting is [On]), the Input select menu appears if you press the INPUT button p.43 . � If no signal is being output from the connected equipment, pressing the INPUT button does not change the input and �There is no other input signal.� will appear.

2 Select the language and the lamp power (When using the �rst time).
When the projector is used for the �rst time after purchase, the start menu for language (to display the menus and messages on the screen) and lamp power selection and con�guration is displayed in English. (If the screen is out of focus, adjust it according to the step 6 .)
1

5 Projector placement angle adjustments
The placement angle and the height of the projected image can be adjusted by the foot adjuster.
1

Use the , , or press the button.
English French German Italian Spanish Portuguese Russian Swedish Turkish

button to select the desired language and

Polish Norwegian Finnish Czech Hungarian Greek Danish Dutch Rumanian

Japanese Chinese (simplified) Chinese (traditional) Korean Indonesian

Lift up the front of the projector to the desired angle, then press the foot adjuster release button.
The foot adjuster extends. Release the button to lock the position.

2

To �ne adjust the angle, twist the foot adjuster. To adjust the horizontal angle, use the right and left tilt adjusters.

3

Message for setup con�rmation is displayed in a selected language. Then, the menu for lamp power selection and con�guration is displayed. It is automatically set as Standard. To change the setting, follow the step 2 .
2

Note
� When [Auto keystone] is set to [On] in the Default setting 1 menu, the keystone distortion will automatically be corrected based on the projector placement angle. If you do not desire the automatic keystone correction, set [Auto keystone] to [Off].

Use the button.

or

button to select the lamp power and press the
button. The display

The lamp power, if selected, will be toggled without pressing the automatically disappears in a few seconds.

Notes
� When the projector is turned on the next time, the start menu does not appear upon startup. However, if [Reset all] is executed from the Default setting 2 menu p.44 , the start menu will be displayed the next time when the power is turned on. � The language can also be set via the Display setting menu p.40 and Lamp power via the Default setting 2 menu p.44 . � This owner�s manual assumes that English has been selected.

6 Adjusting the screen size and focus
1

If you wish to make the screen size smaller, use the ZOOM button to adjust the screen size. Use the focusing lever to adjust the focus.

Control panel

Focusing lever

2

3 Activate the connected device.
Turn on and start the connected device such as a computer.

7 Adjusting the volume with the buttons
The speaker volume can be adjusted when an audio signal is being input.

4 Press the INPUT button.
An image of the connected equipment is projected. Each time you press the INPUT button, it switches to the input of the connected equipment that is outputting video signals.

28

29

Operations

� To stow the foot adjuster, hold up the projector while pressing the foot adjuster release button, then slowly lower the projector.