Tape dubbing
� The recording level is automatically set to the optimum level during dubbing. � The Dolby NR System of Deck A is automatically used to record the tape in Deck B. If you wish to monitor the signal from a Dolby NR encoded tape during dubbing, be sure to set the Dolby NR to match the type of Dolby NR with which the cassette was recorded.
1
ONKYO
2
3
4
Tape dubbing
1
2 3
DECK-A PLAY
REVERSE MODE
DECK-B PLAY
1. Insert the prerecorded cassette into Deck A , and insert the cassette to be recorded into Deck B. 2. Set the Reverse Mode by pressing the REVERSE MODE button repeatedly until the desired mode is displayed. ( v ) one side: Only one side of the tape is copied. ( b ) repeat: Both sides of the tape are copied. 3. Check the Deck A and Deck B direction indicators to ensure that the tape will start in the desired direction. � To dub an entire tape, be sure to select the forward ( s ) direction on both Decks. � To change the setting of the Direction indicator, press the a or s button followed by the e button. 4. Begin dubbing by pressing the NORMAL or HIGH button. [NORMAL] : Normal speed dubbing will begin. [HIGH] : High speed dubbing about half the time normally required will begin.
4
DUBBING NORMAL HIGH
DUBB.STOP
Stopping dubbing
Press the Deck B e (DUBB.STOP) button.
Briefly interrupting dubbing t
Press the t button. In this case, you can change the cassette in Deck A or search the desired portion by using the buttons for Deck A. To resume dubbing, press the NORMAL or HIGH button or Deck B a or s button again.
