PIONEER SX-SW77/WVXCN
Manual de Usuario

Speaker Setup Guide

Speaker Setup Guide
Safety precautions when setting up
When assembling the speakers, lay them down flat on their side to avoid accidents or injury. Make sure to use a stable surface when assembling, setting up, and placing the speakers. Caution � Please don�t use the any attachments with the front speakers other than the brackets provided. 1 Attach the front speaker stand bases to the stems using the screws provided. Before securing the base to the stand, thread the speaker wire through the holes provided on the base as shown below. Then, once you have aligned the stem and base, secure with the small screws at the points shown at right.
Center Receiver subwoofer

Home theater sound setup
Depending on the size and characteristics of your room, you can place your speakers in one of two ways using this system:1 � Standard surround 5-spot setup � This is a standard multichannel surround sound speaker setup for optimal 5.1 channel home theater sound.

Front left

Front right

Surround left

Surround right

Listening position

2 Attach the smaller non-skid pads to the base of the center speaker. The four large non-skid pads are for the receiver subwoofeer (as shown). Use the supplied adhesive to attach 4 pads to the base of each speaker.

� Connect the speaker system. Refer to Connecting up to connect the speakers properly. Place them as shown in the diagram above for optimal surround sound.

Non-skid pads (small) x 4

Center speaker

After placing your speakers, complete Channel level setting on page 29 then refer to Speaker distance setting on page 29 to complete your surround sound setup.
Non-skid pads (large) x 4 Receiver subwoofer

Note
1 See About the listening modes on page 24 for more on using the different listening modes with each speaker setup.

6
En