HORIZONTAL/VERTICAL CIRCUIT ADJUSTMENT
NO. Adjustment part 1 V-AMPLITUDE 50 V-LINEARITY 50Hz V-SCORRECTION 50Hz V-RHASE(50) (V-CENTER) H-RHASE(50) (H-CENTER) H-SIZE E/W-PARABOLA (SIDE-PIN) V-BIAS V-�CORRECTION EW-CORNER (SUB-SIDEPIN) TRAPEZIUM Waveform and others The receiving channel in ( ) are the following signals. (E-2): Crosshatch (50Hz) Already preset (**). (Adjust this unless the linear- (E-5): Monoscope (50Hz) ity is achieved.) Align the center of the screen to the geometric center of CRT. (E-5) Align the center of the screen to the geometric center of CRT. (E-5) Adjust the overscan to 8.5% ± 0.5%. (E-5) Adjust the 1st vertical line from the left and right ends of the crosshatch to be straight. (E-2) Already preset. Already preset. Adjust the end of the line of the crosshatch to be straight. Already preset. (Adjust if the quality is specially poor.) Adjusting procedure and conditions Adjust the overscan to 8.5% ± 0.5%. (E-5) Adjust the linearity to the best.
V-COMPENSATION Already preset. (Adjust if the quality is specially poor.) H-COMPENSATION Already preset. (Adjust if the quality is specially poor.) OTHER However, if it is largely deviated when On the items of V-AMPLITUDE60, V-LINEARITY60, it is checked in the 60Hz mode, V-SCORRECTION60, V-RHASE60, H-RHASE60 readjust it in the 60Hz mode. and H-SIZE60, the compensation data is automatically input if the 50Hz mode adjustment is done.
2
Focus adjustment
1 Receive E-5CH (crosshatch pattern). 2 With the remote controller, make the image normal. 3 Adjust the focus VR to make the vertical line of "5" in "E-5" display upper left part of screen as fine as possible.
This vertical line make as fine as possible.
