PIONEER S-W80S/MLXCN
Manual de Servicio

S-W80S

8. PANEL FACILITIES AND SPECIFICATIONS
FRONT PANEL REAR PANEL

STANDBY/ POWER ON

POWER

1 2
PHASE � 0� _ 180� TURNOVER LEVEL

6 3
LINE LEVEL OUTPUT
50 Hz 200 MIN MAX

7 8 9

SPEAKER LEVEL

4 5
LINE LEVEL INPUT

R

L
OUTPUT

+

-

-+

INPUT

1 Power Indicator (STANDBY/POWER ON)
When power is switched on, the power indicator lights green. If no signal is present for more than 8 minutes, the subwoofer automatically revents to standby mode and the power indicator lights red. If, subsequently, a signal is received, power automatically comes back on and the power indicator lights green. * If you not using the unit for an extended period of time, please switch off using the power switch, and make sure that the power indicator goes out.

6 Turnover knob (TURNOVER)
Sets the high limit of the frequency played back by the subwoofer. � Setting Criteria 50Hz ................ when the diameter of the left/right speakers is 20 cm or more. 100Hz .............. when the diameter of the left/right speakers is 10-25 cm. 200Hz .............. when the diameter of the left/right speakers is 12 cm or less.

2 Power Indicator (STANDBY/POWER ON)
When pressed, power is turned ON; when pressed again, power is turned OFF.

7 Level knob (LEVEL)
Sets the subwoofer volume. � Turn the knob slowly from the MIN position. � With the unit, the bass level can be independently set, so do not turn up the bass on the stereo amplifier.

3 Phase Switch (PHASE � 0° / _ 180°)
When depressed (_ 180º), the output phase becomes the reverse of the input signal, and when raised (� 0º), it is in the same phase as the input signal.

8 Speaker Level Output terminals
(SPEAKER LEVEL OUTPUT) When the speakers output terminals on the stereo amplifier are connected to this unit's SPEAKER LEVEL INPUT terminals 9 and used as the unit's input signal, these terminals are used to connected the left and right speakers via the unit.

� Normally, the switch is set to (� 0º).
But when the sound connection between the subwoofer and the left and right speakers sounds unnatural, try switching to 180º and set the switch in the position where the sound is natural.

9 Speaker Level Input terminals
(SPEAKER LEVEL INPUT) Connect to the speakers output terminal on the stereo amplifier, with the specially provided speaker cords.

4 Line Level Output terminal (LINE LEVEL OUTPUT)
Used for connection other equipment through the amplifier.

5 Line Level Input terminal (LINE LEVEL INPUT)
Connectors to the stereo amplifier's SUBWOOFER PRE-OUT terminal, with the specially provided RCA plug cord.

14