TIMER RECORDING (cont.)
You can programme a timer recording that starts within 24 hours using the JOG dial on the recorder.
24 Hour Express Timer Programming
Before performing the 24 Hour Express Timer Programming:
� Make sure that the recorder�s built-in clock is set properly. � Select the deck. � Set the tape speed. � For the VHS deck: Insert a VHS (or S-VHS) cassette with the record safety tab intact. For the DV deck: Insert a Mini DV cassette with the erase protection switch set to �REC�.
A Enter the programme mode.
Press 24H EXPRESS # on the recorder. The start time indicator ( ) starts blinking on the front display panel.
� The current tape speed and VPS/PDC setting appear on the front display panel, but it is impossible to change the setting. You can only change the setting after programming ( pg. 42).
B Set the programme start/stop time and
channel.
Turn the JOG dial to the left or right to set the time you want recording to start.
� One click stop of the JOG dial changes the time in 5-minute intervals.
Push the JOG dial. The stop time indicator ( ) starts blinking on the front display panel. Turn the JOG dial to the left or right to set the time you want recording to stop.
1 3 2
Push the JOG dial. Turn the JOG dial to the left or right to select the channel you wish to record.
� You can cancel the setting at any time by pressing and holding the JOG dial for more than 3 seconds or pressing & on the remote control. Repeat the step 2.
C Engage the recorder�s timer mode.
Press 24H EXPRESS #. The recorder turns off automatically and �#� appears on the front display panel.
� To disengage the timer mode, press # (TIMER) or 24H EXPRESS # again.
