JVC SR-VS20EK
Manual de Usuario

47
ENGAGE AUDIO DUBBING
Press A. DUB.
Y A L P
1 2

5
AUDIO

1 4 7

2 5 8 0

3 6 9
3 4 4

� It is possible to take the original sound recorded on the tape in your recorder and mix it with other sounds from a microphone, CD player etc. To perform this audio dubbing with audio mixing, connect as in the diagram on page 46. � Your recorder enters the Audio Dubbing Pause mode. (" " blinks, " " and " " light up on the front display panel.) � To perform audio dubbing with audio mixing, press AUDIO on the remote control to select "HIFI L R" or "L R" at this point. When using the DV deck as the recording deck, also make sure that "12BIT MODE" is set to "SOUND1" ( pg. 35). * Audio dubbing with audio mixing is not possible if you're using a monaural audio component, or if you don't have an audio mixer.

1 2

3

START DUBBING

6
STOP PAUSE

Engage the audio component's Play mode, then press PLAY to start the tape in your recorder. Audio dubbing begins at this point. deck, set "12BIT MODE" to "SOUND2". ( pg. 35) � " " blinks and " " is displayed on the front display panel. � To stop dubbing temporarily, press PAUSE. Press PLAY to resume dubbing.

� When monitoring the audio-dubbed sound on the DV

END AUDIO DUBBING

7

Press STOP to stop the tape in your recorder, and engage the audio component's Stop mode.

NOTES:

� Once the Audio Dubbing starts, you can not use the other deck. � When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically selected. If you wish to hear the mixed sound (Hi-Fi + Normal soundtracks), press AUDIO on the remote control to select "HIFI NORM" (VHS deck only pg. 34). � Audio dubbing stops automatically when the counter reaches "0:00:00", and the recorder enters the Play mode (VHS deck only). Check the counter reading before dubbing. � Audio dubbing is also possible using the rear panel AV1 (L-1) IN/OUT or AV2 (L-2) IN/DECODER connector. When using these connectors, make sure to select the correct input mode in step 3. � Audio dubbing cannot be performed on a VHS/S-VHS cassette that has had its record safety tab removed, or on a Mini DV cassette that has had its erase protection switch set to "SAVE". � When playing back an audio-dubbed tape on the VHS deck, press AUDIO on the remote control to select the soundtrack you wish to hear ( pg. 34). When playing back an audiodubbed Mini DV tape on the DV deck, set "12BIT MODE" to "SOUND2" ( pg. 35). � Audio dubbing is not possible using the DV IN/OUT connector.