ROLAND SPD-20
Manual de Usuario

Reading SPD-11 Data with the SPD-20
You can use the SPD-20 to receive bulk data (bulk load) from the SPD-11. The SPD-20 has all of the Instruments from the SPD-11 built in, allowing you to play back Patches and other data created on the SPD-11.
fig. 86-a

MIDI OUT

MIDI IN

1

SPD-11

SPD-20

2

When SPD-11 data is sent to the SPD-20, Patches 1�64 from the SPD-11 are stored in Patches 1�64.

NOTE

When data is received by the SPD-11, the SPD-20�s Patch data is overwritten. You cannot transmit SPD-20 data to the SPD-11.

1 2 3 4
NOTE

Using a MIDI cable, connect the MIDI OUT of the SPD-11 to the MIDI IN of the SPD-20. Match the SPD-11�s Basic Channel with the Basic Channel the SPD20. (p. 67) Put the SPD-11 in Edit mode and select the BULK DUMP SYSTEM parameter. Select the SPD-11 Patches (ALL, 1�64) to be forwarded.

3

4

When transmitting data, the SPD-11�s Patch Number is written as is to the same Patch Number on the SPD-20. When ALL is selected, then Patches 1�64 from the SPD-11 are written to Patches 1�64 on the SPD-20.

5

5 6
MEMO

When you press [ALL/ENTER] on the SPD-11, the data is forwarded from the SPD-11 to the SPD-20. When reception begins, �Lod� appears in the SPD-20�s display.
Bulk Load is then completed.

When transferring Patches 1�64 used for Patch Expand on the SPD-11 (p. 70) to the SPD-20, you must then use Patch Copy to copy Patches 1�64 on the SPD-11, to Patches 96�99 on the SPD-20.

77