|
|
|
Usuarios conectados
Actualmente hay 5939 visitantes y
1 usuarios online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
ORDER NO.
RRV2288
SPEAKER SYSTEM
S-L9-A-LRW
65S This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely repair complex products such as those covered by this manual. Improperly performed repairs can adversely affect the safety and reliability of the product and may void the warranty. If you are not qualified to perform the repair of this product properly and safely, you should not risk trying to do so and refer the repair to a qualified service technician. WARNING This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to cause cancer, birth defects or other reproductive harm. Health & Safety Code Section 25249.6 � Proposition 65
XC/1
¶ The components used for the S-L9-A-LRW/XC and the S-L9-A-LRW/XC/1 are interchangeable. So, their service parts are the same.
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
[ S-L9-A-W ]( Subwoofer ) The speaker element is attached to the back board by 4 external screws. To detach it, unfasten those screws. When attaching it, face its terminal upward. The duct is attached to the baffle by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side. The input terminal is attached to the back board by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side. [ S-L9-A-LR ] ( Satellite Speaker ) The grille is attached to the cabinet by catches. To detach it, pull it toword you. The speaker element is attached to the inner baffle by 2 internal screws. To detach it, first remove the cabinet. Then unfasten those screws. When attaching it, face its terminal lower left. The cabinet is attached to the baffle by 7 external screws. To detach it, unfasten those screws. The input terminal is attached to the cabinet by 2 internal screws. To detach it, first remove the cabinet. Then remove the input terminal.
PIONEER CORPORATION
4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2000
T-ZZM MAY 2000 Printed in Japan
|
|
|
> |
|
