|
|
|
Usuarios conectados
Actualmente hay 6043 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Front
Rear Center
ORDER NO.
RRV2192
S-HS88-F
S-HS88-CR
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
[ Front speaker ] The grille is attached to the cabinet by catches. Detach by pulling it toward you. The woofer is attached to the baffle by 4 external screws. To detach it, unfasten those screws. When attaching upper one, face its terminal downward. When attaching lower one, face its terminal upward. The midrange is attached to the flange lower side by 4 external screws. To detach it, unfasten those screws. When attaching it, face its terminal downward. The tweeter is attached to the flange upper side by 2 external screws. To detach it, unfasten those screws. When attaching it, first reattach the packing around tweeter diaphragm, then face its terminal downward. The flange is attached to the baffle by 4 external screws. To detach it, unfasten those screws. When attaching it, face it downward. To detach the midrange or tweeter, first remove the flange. Then remove it. The input terminal is attached to the back board by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side. The Network Assy is attached to the input terminal by soldaring.
4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER ELECTRONIC (EUROPE) N.V. Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
SPEAKER SYSTEM
XMA/NC
XMA/NC
[ Center speaker ] The grille is attached to the cabinet by catches. Detach by pulling it toward you. The woofer is attached to the baffle by 4 external screws. To detach it, unfasten those screws. When attaching it, first exchange the flange, then face its terminal downward. The tweeter is attached to the baffle by 4 external screws. To detach it, unfasten those screws. When attach it, do so that it will move vertical. The tweeter wires, connected in the middle of network Assy , are covered with the insulating tape. The input terminal is attached to the back board by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side. The Network Assy is attached to the input terminal by soldaring.
[ Rear speaker ] When exchange the rear speaker, do it with the CS Assy (R).
PIONEER CORPORATION
PIONEER CORPORATION 1999
T-ZZM SEP. 1999 Printed in Japan
|
|
|
> |
|
