Fader start function
You can start music play from the SL-DZ1200 direct drive digital turntable (not included) using the channel fader and cross fader by connecting the digital turntables to CH1 and CH4. (A control cable is necessary for this connection. page 8)
Start using the cross fader
When the digital turntable you want to control is connected to CH1 and the cross fader operation switch is set to NORMAL.
1 2 3 4
Turn [ASSIGN A] and select 1 Push [CROSS FADER] all the way in the direction opposite the source you want to start ( ) Switch [FADER START (CH1)] to ON Slide [CROSS FADER] in the direction opposite of instruction 2 when you want to start play
�Play instantly begins from the digital turntable.
If you push the cross fader back to the original position after play on the digital turntable has started, the digital turntable returns to the set point and waits in the standby position.
Before use
�Turn [MODE] to TURNTABLE on the rear panel of the digital turntables connected to CH1 and CH4. �Set the auto cue point and cue point on the digital turntables connected to CH1 and CH4, and standby at the set point.
Alternate play of two digital turntables connected to CH1 and CH4
When the cross fader operation switch is set to NORMAL.
1 2 3 4
Turn [ASSIGN A] to select 1 and turn [ASSIGN B] to select 4 Push [CROSS FADER] all the way in the direction opposite the source you want to start ( ) Switch [FADER START (CH1)] and [FADER START (CH4)] to ON Push [CROSS FADER] all the way in the direction opposite of instruction 2 (towards ), when you want to start play
�Play instantly begins from the digital turntable connected to CH1. (At the same time, the digital turntable returns to the set point when playing on CH4)
Start using the channel fader
When the digital turntable you want to control is connected to CH1 and the channel fader operation switch is set to NORMAL. �When individually adjusting the left (L) and right (R) input ( page 12), perform the following instructions simultaneously for the CH1 and CH2 channel faders on the panel.
1
Turn [ASSIGN A] and select any number other than 1
�The channel fader will not start the digital turntable if 1 is selected.
2 3 4
Push the channel fader all the way to zero Switch [FADER START (CH1)] to ON Push the channel fader up when you want to start play
�Play instantly begins from the digital turntable.
5
Push [CROSS FADER] all the way in the direction opposite of instruction 4 (towards )
�Play instantly begins from digital turntable on CH4. �Play on CH1 instantly returns to the set point.
If you push the channel fader back to the original position (zero) after play on the digital turntable has started, the digital turntable returns to the set point and waits in the standby position.
Note While you are using the fader to start play, turning the unit off and on may stop or start the digital turntable.
