SHARP SF-A58
Manual de Servicio

8. Adjust the center of the copy.
Set an original in the ADF tray and make a copy. When the copy is off center as shown in Fig. 1 or Fig. 2, loosen the two tray securing screws and adjust the tray by moving it in direction A or B as shown in the figure.

Setup example (1) If the leading edge of the original was not fed all the way to the stopper, enter value which will move the original toward the stopper side. 7, 6, 5, 4...

Mark

Tray securing screw

Original Stopper Glass

B

A

(2) If the copy image at the leading edge was distorted, enter value which will move the original toward the glass side. 9, 10, 11...
Original Stopper Glass

�

When off center as shown in fig. 1 Move the tray in direction A and secure it with the two mounting screws. Make a copy to check whether it is centered properly.

(3) If the original overrode the stopper, enter value which will move the original toward the glass side. 9, 10, 11, 12 ...
Original Stopper Glass

Fig. 1

Center of copy paper

�
Center of original image (first copy)

After selecting test command 53 , enter a selected set value between 0 and 15 using the copier keys.
C 0/ 5 (a) 0/ 1 (b) (a) One-sided mode (b) Two-sided mode 3

�

When off center as shown in fig. 2 Move the tray in direction B and secure it with the two mounting screws. Make a copy to check whether it is centered properly.

Fig. 2

Center of copy paper

Center of original image (first copy)

9. Adjust the position of the leading edge of originals

� �

The position of the leading edge of originals fed from the ADF can be determined using test command 53 . Although the leading edge has been factory set to stop at location 8, it may need to be adjusted depending on the type of originals. The leading edge position can be adjusted within a range of 8 mm (8 steps) on the stopper side and 7 mm (7 steps) on the glass side in 1 mm increments. Adjustment can be done separately for the one-sided, two-sided, and thin paper modes.
8 0 1 2 3 4 8mm 5 6 7 9 10 11 12 13 14 15 7mm

Set to between 0 and 15 as dictated by the copier's performance. The factory setting is "8".

Stopper Glass View from the operator side

�4�