SHURE SCM268E
Manual de Usuario

INSTALLATION
SUPPLIED HARDWARE
� � 4 rubber feet. For stand-alone installation. 1 rackmount bracket, long. For half-rack (single unit) installations. 1 rackmount bracket, short. For half-rack (single) or dual-mount installations. 2 straddle brackets. For dual-mount or fixed installations. 12 bracket screws, 1/4 in. (6 mm). For securing the brackets to the chassis. 4 rackmount screws, 1 in. (2.5 cm). For mounting the unit in a rack. 4 plastic washers. For use with the supplied rackmount screws. 4 wood screws, 1/2 in. (1.25 cm). For fixed installations. 2.

Attach the short rackmount brackets to the outsides of the combined units with eight (8) of the bracket screws.

ENGLISH

� � � � � �

3.

After attaching the brackets, mount the unit in an equipment rack using the supplied rackmount screws and plastic washers.

Bracket Screw Rackmount Screw Wood Screw

STAND-ALONE INSTALLATION
Adhere the four (4) supplied rubber feet to the bottom of the unit at each corner. This will keep it from sliding and protect the table surface.

RACKMOUNT INSTALLATION
The SCM268 can be mounted as a single unit or dual-mounted with either another SCM268 or another Shure half-rack unit such as the SCM262 or DFR11EQ. Attach the rackmount brackets using one of the following methods: Single unit (half-rack) installation: 1. Attach the short and long rackmount brackets to the SCM268 with eight (8) of the supplied bracket screws.

FIXED INSTALLATION
To permanently affix the SCM262 above or below a table, shelf, or counter top, use the following steps: 1. Fasten the straddle brackets to the recessed edges of the chassis using four (4) bracket screws.
Top mount: Fasten the straddle brackets to on the bottom of the unit Hanging mount: Fasten the straddle brackets to the top of the unit.

2. Dual-mounted installation: 1.

Fasten the straddle brackets to the surface using the four (4) supplied wood screws.

Connect the two units together side-by-side using two (2) straddle brackets. The brackets should straddle the recessed edges on on the top and bottom of each chassis. Fasten them using eight (8) bracket screws.

NOTE: Be sure to use both straddle brackets-one on the top and one on the bottom.

TOP MOUNT

HANGING MOUNT

8