4 optical pick-up block (KHM-230AAA/J1NP) Note: When installing the BU on the chassis, set the lever (lifter) in free position, the gear (U/D) in UP position, and insert the shaft b into the groove of gear (U/D). BU section gear (U/D)
b
5 four compression springs
1 two screws (PTPWH M2.6) 8 RF board
7 three screws (BVTP2.6 � 8)
6 connector (CN002)
3-8. TABLE ASSY
9 three screws (BTTP M2.6) 0 bracket (guide) gear (loading C)
7 two screws (BTTP M2.6) 8 bracket (guide 2)
e qa table assy
4 wire (flat type) (6 core) (CN15)
5 three screws (BTTP M2.6) 3
2 two screws (BVTP 3 � 8)
6 bracket (guide)
Note: When installing the table assy on the chassis assy, engage the gear (loading C) with the groove by looking into the gear through a hole e in the table assy. d c
1 Slide the tray until the screw that fixes the bracket (guide) can be seen through a round hole c , d in the table assy.
