SONY SCDC222ES
Manual de Servicio

SCD-C222ES

Set Check
92. SET CHECK SET TEST START 10. TOTAL CHECK 120. MANUAL CHK 121. LOAD IN ? (Not used) 122. SPIN UP ?

0. IC&FL CHECK ?

11. AUTO CHECK ?

1. TOTAL CHECK ?

12. MANUAL CHK ?

2. F.JUMP CHECK ?

13. DISP RSLT ?

123. PARAMETER ?

3.HYB CHECK ?

TOTAL CHK END ?

124. READ TOC & PSP ?

4. DISP ERROR ?

125. 1/3 SEEK ?

END ??

126. 1-M SEEK ?

127. ERR RATE ?

128. HENSHIN ?

129. SPIN DOWN ? 12A. LOAD OUT ? (Not used) MAN. CHK END?

Press the [l AMS L] dial when No.sssss sssss*1 is displayed, and a checking for that display will start or the lower layer will be selected. For the selection on the same layer, rotate the [l AMS L] dial. It is looped on the same layer, and when �END?� is displayed, press the [ l AMS L ] dial to return to the upper layer. *1 s denotes a displayed character. Manual Check Method In the �12. MANUAL CHK�, individual checks (121. LOAD IN to 12A. LOAD OUT) are possible.
Example: If 124. READ TOC & PSP of 12. MANUAL CHECK is to be checked.

Setting Method: 1. After setting the test mode, rotate the [l AMS L] dial to select �92. SET CHECK� and press the [l AMS L ] dial to enter. 2. When �SET TEST START� is displayed, rotate the [ l AMS L ] dial clockwise by 2 clicks to select �1. TOTAL CHECK?� and press the [ l AMS L ] dial to enter. 3. When �10. TOTAL CHECK� is displayed, rotate the [l AMS L] dial clockwise by 2 clicks to select �12. MANUAL CHK?" and press the [ l AMS L ] dial to enter. 4. When �120. MANUAL CHK� is displayed, rotate the [l AMS L] dial clockwise by 4 clicks to select �124. READ TOC & PSP?� and press the [l AMS L ] dial to enter. 5. A checking will start automatically.
Note: In making a check, the disc must be loaded. Immediately when a check started, the tray is drawn into the set. Also, the tray can be opened/closed even during the set check mode.

18