|
Usuarios conectados
Actualmente hay 5853 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
XP SBC RU 538/87.2 10-02-2004 09:54 Pagina 6
Instructions for use Setting the remote control
This is only necessary if your appliance does not respond to the RU538. If that is the case, the RU538 does not recognize the brand and/or model of your appliance and you need to program the remote control to do so. The example below (TV) instructs you how to do this. You can repeat the same steps for other appliances (VCR, DVD player/recorder) which you want to operate using the RU538. Example of TV: 1 Turn on the TV manually or use the original remote control. Tune in to channel 1. 2 Look up the brand of your TV in the code list at the back of this manual. One or more four-figure codes are shown for each brand. Note the first code. Be careful! There are separate tables for TV,VCR and DVD. Make sure you use the codes from the correct table. 3 Select TV with the mode selector. (See �Testing the remote control�.)
TV VCR DVD
English 6
TITLE
DISC
....
4
Keep keys �1� and �3� pressed simultaneously for three seconds until the green light under TV in the selector window flashes twice and then remains lit.
ME
N
U
OK
1 4 7
2 5 8 0
3 6 9
5
�
6
�
Then enter the code noted in step 2 using the digital keys. The green light in the selector window will now flash twice. If the light flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. Start again from step 2. Point the RU538 at the TV and check that it responds as it should. If the TV responds to all of the key commands, the RU538 is ready for use. Do not forget to note your code. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list.
SHIFT
�
|
|
|
> |
|