|
|
|
Usuarios conectados
Actualmente hay 5826 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Oven
Racks
and
Rack
Supports
(h'en Racks: To remove, pull forward to the "stop" position; lift up on the front of the rack and pull out. Oven i_,lck SulDpo_s: To remove, lift support holders from slots at the front of the oven then move supports away from oven wall. Pull forward to remove from oven. To replace, reverse procedure. Be sure front supports are correctly in place so that racks will be level.
Oven
Thermostat
Knob
Adjustment
The oven thermostat knob can be adjusted if the oven temperature is too low or too high and the length of time to cook ALL foods is too long or too short. Do NOT adjust the thermostat knob if only one or two items are not baking properly. To adjust the lhernzosla/knob: _._Triangle
Turn ove0 the t ermostat k0o0 ,o
Remove the knob and turn it to the under-
//
_ __ II_i_ie_ll _k\ °-z.__ _ _,j _ "_ _ o "_ _c ,4 >,
\S°0'°'°w
/_-Skirt ,. J FIG. 1
top. (See Fig. 1) Loosen the two screws slightly. Holding the skirt in place, move the neathside. Holditsothatthetriangleisatthe top screw by rotating the knob one notch, as noted by one click, in direction necessary. If notch indentation is notapparent, tighten screws until clicking is heard. There are five notches in each direction. One notch equals approximately IO° F. EXAMPLE: If the oven temperature is too
knob should period to to move a longer time be rotated cook, the the top screw toward the word "HOTTER". (See Fig. 2) Tighten the screws while tightly holding knob to skirt. To replace knob, match flat part of knob opening with springrequiring cool and ALL foods are on the shaft, returning to OFF position.
^_,_s_R°_&, I
_
_ _o_cH _o_ P'_ _ _.! (_i_)i! _..._, "_..._ "_ _
/ FIG. 2
IMPORTANT: The oven thermostat knob should be adjusted one notch and then the oven should be tested. (We recommend baking 2 -- 9" yellow layer cakes using a purchased box mix.) If the oven temperature is still too low or too high, repeat the procedure described above. If the knob is rotated too far or in the wrong direction, rotate the knob in the opposite direction until the center of the screw is directly under the triangle, which is the starting point. Initiate the procedure again until the desired temperature is reached. 41
|
|
|
> |
|
