Su carrito de compras está vacío
 
English Polski Spanish 
Buscar un manual
 

(p.Ej. AA-V20EG JVC, ZX-7 Sony)
PayPal 1000+ rating Secure, Encrypted Checkout.
 
Usuarios conectados
Actualmente hay 6034 visitantes online.
Productos
Información
Destacado
Inicio >> JVC >> RX-E112RSL Manual de Usuario
 
 0 artículo(s) en Su carrito 

JVC RX-E112RSL
Manual de Usuario


¡Twitee acerca de este producto y obtenga $1.00 de crédito en la tienda para uso!
  • Descargable
  • Formato PDF
  • Manual completo
  • Idiomas: English
Precio: $4.99

Descripción del JVC RX-E112RSL Manual de Usuario

Manual del propietario completo en formato digital. El manual estará disponible para descarga como archivo PDF después de que lo compre.

El Manual del Propietario (a veces llamado Manual del Usuario o Guía del Usuario) contiene información sobre cómo utilizar su dispositivo. Después de colocar la orden le enviaremos las instrucciones de descarga a su dirección de e-mail.

The manual is available in languages: English

Not yet ready
You must purchase it first

Opiniones de los clientes
No hay comentarios de productos.

TEXT_PDF_SNIPPET
AM (MW/LW) antenna connection
Connect the AM (MW/LW) loop antenna supplied to the AM LOOP terminals. Turn the loop until you have the best reception. � If the reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. Keep the AM (MW/LW) loop antenna connected.

Connecting the Speakers
After connecting the front, center and rear speakers, and/or a subwoofer, set the speaker setting information properly to obtain the best possible Surround effect. For details, see page 15. CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

FM antenna connection
Connect the FM antenna supplied to the FM 75 � COAXIAL terminal as temporary measure. Extend the supplied FM antenna horizontally. � If the reception is poor, connect an outdoor FM antenna (not supplied). Before attaching a 75 � coaxial cable (with a standard type connector), disconnect the supplied FM antenna.

Connecting the front, center, and rear speakers

1

2
2 1

3

Notes: � If the AM (MW/LW) loop antenna wire is covered with vinyl, remove the vinyl while twisting it as shown on the right. � Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

For each speaker, connect the (+) and (�) terminals on the rear panel to the (+) and (�) terminals marked on the speakers respectively.

1 Cut, twist and remove the insulation at the end of each speaker cord (not supplied). 2 Press and hold the clamp of the speaker terminal (1), then insert the speaker cord (2). 3 Release the finger from the clamp.
Connecting the subwoofer speaker
By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.

RIGHT RIGHT

LEFT/MONO

Getting Started

INPUT (LOW-LEVEL)

Powered subwoofer (example)

SUBWOOFER OUT

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied). � Refer also to the manual supplied with your subwoofer.

Note: You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you.

5

Quizás también quiera comprar

$4.99

RXE112RSL JVC
Manual de Servicio

Manual de servicio completo en formato digital (archivo PDF). Los manuales de servicio por lo genera…
>
Parse Time: 0.153 - Number of Queries: 95 - Query Time: 0.036