RX-E100RSL/RX-E100RSB Removing the audio board (See Fig.8)
CN515 power supply board Main board CN517 CN516
Prior to performing the following procedure, remove the top cover , the rear panel and the each board. 1. Disconnect the card wire from connector CN411 on the audio board. 2. Disconnect the harness from connector CN205 on the audio board. 3. Disconnect the harness from connector CN515, CN516, and CN517on the main board. 4. Remove the harness band fixing the harness. 5. Remove the three screws G board assembly. attaching the audio
CN411
G
Power transformer
Audio board
Harness band
CN205
Power / Fuse board
Fig.8
H H I I H
Main board
Removing the main board
(See Fig.9)
CN707 CN206
Prior to performing the following procedure, remove the top cover, the rear panel and audio board. 1. Remove the harness band fixing the harness. 2. Disconnect the harness from connector CN707 on the power supply board . 3. Disconnect the harness from connector CN202 and CN206 on the main board . 4. Remove the five screws H and the two screws I attaching the main board.
CN202 Harness band
H
Fig.9
J
Removing the Heat sink (See Fig.10 to 11)
1. Remove the ten screws K and four screws L attaching the heat sink. 2. Remove the two screws J attaching the heat sink from the rear side of main board.
Main board rear side Heat sink
