JVC RX8022RSL
Manual de Servicio

RX-8022RSL

Disassembly method
Removing the top cover (See Fig.1)
1. Remove the four screws A attaching the top cover on both sides of the body. 2. Remove the three screws B on the back of the body. 3. Remove the top cover from behind in the direction of the arrow while pulling both sides outward.

Top cover

B

A(both sides)
Fig.1

Removing the front panel assembly
Prior to performing the following procedure, remove the top cover. 1. Cut off the tie bands. 2. Disconnect the harness from the connector CN416 (on the video audio board), CN206 (on the video board) and CN244 (on the S video board) (see fig.8). 3. Disconnect the card wire from the connector CN400 on the audio board and CN402 on the power supply board. 4. Remove the three screws C fixing the upper surface of the front panel assembly, and four screws D fixing the bottom. 5. Detach the front panel assembly toward the front.
Main board Audio board CN400

(See Fig.2 and 3)

C

Front panel assembly

C
Power supply board CN402 Tie band

Compu link board

CN393

Fig.2

D
6. Remove the screw X attaching the earth wire (see fig. 19).

Front panel assembly

Removing the compulink board (See Fig.2 and 4)
Prior to performing the following procedure, remove the top cover. 1. Disconnect the harness from the connector CN393 on the compu link board. 2. Remove the two screws E attaching the compu link board to the rear panel. Fig.3

Removing the rear panel

(See Fig.4)

F

F

F

F

E

Cord stopper

Prior to performing the following procedure, remove the top cover. 1. Remove the power cord stopper from the rear panel by moving it in the direction of the arrow. 2. Remove the thirty two screws E & F & G attaching the each board to the rear panel. 3. Remove the three screws H attaching the rear panel on the back of the body.

H

Rear panel

H
Fig.4

F

GH

1-3