JVC RX6510VBK
Manual de Usuario

Adjusting the DAP Modes
Once you have adjusted the DAP modes, the adjustment is memorized for each DAP mode. Before you start, remember... � Make sure that you have set the speaker information correctly (see page 13). � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. � You cannot adjust the rear speaker output level when you have set �REAR SPK� to �NO.� See page 13.

From the remote control:

1. Press DSP MODE repeatedly until the DAP mode � LIVE CLUB, DANCE CLUB, HALL, or PAVILION � appears on the display.
The DSP indicator also lights up on the display.

DSP
MODE

2. Press SOUND.
The 10 keys are activated for sound adjustments.

SOUND

On the front panel:

1. Press DSP MODE repeatedly until the DAP mode � LIVE CLUB, DANCE CLUB, HALL, or PAVILION � appears on the display.
The DSP indicator also lights up on the display.

DSP MODE

3. Adjust the rear speaker output levels.
� To adjust the left rear speaker level, press REAR�L +/� (from +10 dB to �10 dB). � To adjust the right rear speaker level, press REAR�R +/� (from +10 dB to �10 dB).

� REAR � L +

5

ENTER

6

ENTER

� REAR � R +

8

9

2. Adjust the rear speaker output levels.
1) Press ADJUST repeatedly until one of the following indications appears on the display. �REAR L LEVEL�: To adjust the left rear speaker level. �REAR R LEVEL�: To adjust the right rear speaker level. 2) Press CONTROL UP 5/DOWN � to adjust the selected speaker output level (from +10 dB to �10 dB). 3) Repeat 1) and 2) to adjust the other speaker output level.
ADJUST SETTING

4. Press EFFECT to select an effect level you want.
� Each time you press the button, the effect level changes as follows:

EFFECT

1

DSP EFFECT 1
CONTROL DOWN UP

DSP EFFECT 2

DSP EFFECT 3

DSP EFFECT 5

DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger (normally set it to �DSP EFFECT 3�).

3. Adjust the effect level.
1) Press ADJUST repeatedly until �DSP EFFECT� appears on the display. The display changes to show the current setting. 2) Press CONTROL UP 5/DOWN � to select the effect level. � Each time you press the button, the effect level changes as follows:
ADJUST SETTING

CONTROL DOWN UP

DSP EFFECT 1

DSP EFFECT 2

DSP EFFECT 3

DSP EFFECT 5

DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger (normally set it to �DSP EFFECT 3�).

24

English