JVC RX6032VSL / UC
Manual de Servicio

RX-6032VSL

2.14 Removing the power supply board (See Fig.16) � Prior to performing the following procedure, remove the top cover. (1) From the top side of the main body, disconnect the parallel wires from the connectors CN203 and CN241 on the power supply board. (2) Disconnect the card wire from the connector CN201 on the power supply board. (3) Disconnect the relay board from the connector CN291 on the power supply board. (4) Disconnect the parallel wire from the connector CN101 on the headphone jack board. (5) Remove the solders from the soldered section c on the power transformer board 1. (6) Remove the three screws S attaching the power supply board. (7) Remove the power supply board from the hook g of the chassis base bracket in the direction of the arrow, take out the power supply board. (8) Turn over the power supply board, remove the solders from the soldered sections h attaching the wires.

Card wire CN241

S

CN201

Power supply board Parallel wire

CN101 Parallel wires CN203 CN291 Headphone jack board

S
Soldered section h

Relay board

S

Soldered section c

Hook g of the chassis base bracket
Fig.16 2.15 Removing the headphone jack board (See Figs.16 and 17) � Prior to performing the following procedure, remove the top cover and front panel assembly. (1) From the top side of the main body, disconnect the parallel wire from the connector CN101 on the headphone jack board. (See Fig.16) (2) From the front side of the main body, remove the nut and screw T attaching the Bracket(phones) to the chassis base. (See Fig.17)

Power transformer board 1

Headphone jack board Nut Bracket(phones)

T

Chassis base
Fig.17

1-10 (No.22012)