TEAC RWH300
Manual de Usuario

Troubleshooting
In case of trouble with the unit, please take the trouble to look through this chart and see if you can solve the problem yourself before you call your dealer or TEAC service center.

Specifications
Media type CD-RW and CD-R for Digital audio (record and playback), CD (playback only) Frequency converter input sampling frequency 32kHz~48kHz Recording sampling frequency 44.1kHz Frequency response 20Hz~20kHz (playback:±0.5dB, recording:±1dB) Signal to noise ratio More than 93dB(playback) More than 87dB(recording) Dynamic range More than 93dB(playback) More than 87dB(recording) Total Harmonic Distortion Less than 0.007%(playback) Less than 0.009%(recording) Wow & flutter Unmeasurable Audio Input Sensitivity/Impedance LINE : -6dBV(0.5V)/20k� Maximum Iutput level LINE :+6dBV(2.0V) Output Level/Impedance LINE : -6dBV(0.5V)/1k� Maximum output level LINE :+6dBV(2.0V)

No power e Check the connection to the AC power supply. No sound from speakers. eCheck the connection to the stereo system. eNo disc has been loaded. Load a disc. The sound is noisy. eThe unit is too close to a TV set or similar appliances. Install the unit apart from them, or turn them off. Remote control doesn't work. eIf the batteries are exhausted, change the batteries. e Use remote control unit within the range (5m/15ft) and point at the front panel. eClear obstacles between the remote control unit and the main unit. eIf a fluorescent light is near the unit, put it off. Cannot play. eLoad a disc with label side up. eIf the disc is dirty, clean the surface of the disc. eA blank disc has been loaded. Load a prerecorded disc. Cannot stop the shuffle playback. ePress the PLAY MODE button of the remote control unit twice to cancel the shuffle mode. eUnplug the power cord from the AC outlet and plug it again. Sound skips. e Place the unit on a stable place to avoid vibration and shock. eIf the disc is dirty, clean the surface of the disc. e Don't use scratched, damaged or warped discs.

Recording is not possible. eA playback-only disc or finalized disc has been loaded. Use a recordable disc. eAn attempt is made to record digital signal from a source while its digital copy has been prohibited by SCMS. Use analog recording. eThe disc does not have a recordable area. Use another disc. eThe recording level is too low. Adjust the recording level. eCheck the connected components.

If normal operation cannot be recovered, unplug the power cord from the outlet and plug it again.

Beware of condensation
When the unit (or a disc) is moved from a cold to a warm place, or used after a sudden temperature change, there is a danger of condensation; vapor in the air could condense on the internal mechanism, making correct operation impossible. To prevent this, or if this occurs, leave the unit for one or two hours with the power turned on. Then the unit will stabilize at the temperature of its surroundings.

Power supply 120/230 V AC, 50/60Hz (General export model) 230 V AC, 50Hz (Europe model) Power consumption 25 W Dimensions (W x H x D) 215 x 109 x 317 mm (8-7/16"x4-5/16"x12-1/2") Weight (Net) 4.8kg (10-1/2 lb) Standard Accessories Audio signal connection cord x 2 Remote control cord x 1 Remote control unit x 1 Batteries(AA,R6,SUM-3) x 2 < Design and specifications are subject to change without notice. < The illustrations may differ slightly from production models.

66
ENGLISH