1-4-5. V Board
Removal 1. Remove the base assembly. (Refer to Section 1-3-1.) 2. Remove the rear cover and rear panel. (Refer to Section 1-3-3.) 3. Remove the two hooks of the rear panel, then remove the V board. 4. Disconnect the harness from the connector (CN30) on the V board.
1-4-6. Lamp Power Supply Board
Removal 1. Remove the cabinet. (Refer to Section 1-3.) 2. Remove the C board. (Refer to steps 3 to 6 of Section 1-4-1.) 3. Remove the lamp assembly. (Refer to steps 2 and 3 of Section 1-5-2.) 4. Remove the three screws and disconnect the harness from the connector (CN14) on the F board, then remove the lamp power supply unit. 5. Remove the two screws, then remove the lamp house. 6. Loosen the two screws, then remove the connector.
BTP 3 x 12 Lamp power supply unit
Rear panel
Hooks
CN30
BTP 3 x 12 Lamp house Screws
Harness
V board
Connector
Installation 5. Install the V board in the reverse order of steps 3 and 4. 6. Assemble this unit in the reverse order of steps 1 and 2.
