With screws (see Fig. 20 and Fig. 22) To mount the door panel, follow these steps: 1. 2. Open the door 90 degrees. On new refrigerators, the decoration strip is taped inside the door; if installed on the door, remove the door decoration strip (2) by removing its three screws (1). Remove the old panel. Insert the new panel by inserting the vertical edges into the grooves of the door frame (3). Then, push the panel downwards so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). Put the decoration strip across the door so that the gap is covered. Secure the decoration strip with the three screws removed in step 2.
1
With screws
Snap in
1
1 2
1 2
3. 4.
1
1
1
2
5. RM 2455 RM 2555 RM 4605 6.
Snap in (see Fig. 21 and Fig. 22) To mount the door panel, follow these steps: 1. 2. Open the door 90 degrees. On new refrigerators, the decoration strip are taped inside the door; if installed on the door, remove the door decoration strip (2) by gently pushing the four tabs away with a �at blade screwdriver (1). Remove the old panel. Insert the new panel by inserting the vertical edges into the grooves of the door frame (3). Push the panel downward so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). Snap in the decoration strip (2).