JVC RD-T5RBUEN
Manual de Usuario

For private listening Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones.

Using Batteries
Power Batteries (6 pcs.): You can operate the System on batteries. When the batteries are exhausted, �NO BATT� will appear on the display. In this case, replace with the new batteries. Memory Backup Batteries (3 pcs.): Your settings such as the preset stations, clock and timer are backed up with this batteries. CAUTION: If memory backup batteries are exhausted or not installed, and the AC power cord is disconnected or there is a power failure, the settings you have made will be erased from memory in approx. half a day.

Reinforcing the Bass Sound (AHB PRO) [RD-T7RGN Only]
You can reinforce the bass sound to maintain rich, full bass at low volume (you can use this effect only for playback): To get the effect, press the AHB (Active Hyper Bass) PRO button. The �BASS� indicator lights up on the display. To cancel the effect, press the button again. The �BASS� indicator goes out.

Tone Control (BASS/TREBLE)
You can control the tone by changing the bass and treble.

s Press the BASS/TREBLE button until "BASS" 1.
or "TREBLE" appears on the display.
Each time you press the button, the display changes as follows: BASS = TREBLE = original display = (back to the beginning)

s Turn the Jog dial on the Unit or press the 2.
VOLUME +/� button on the Remote Control to adjust the level.
The bass or treble level changes between �6 and +6. (0: Flat)

To exit the tone control mode, press the BASS/TREBLE button until the original display appears, or wait for 15 seconds. To forcibly reset the bass and treble levels to 0 (FLAT), press the BASS/TREBLE button for 2 seconds or more.

Showing the Time (CLOCK/ DISPLAY)
While listening to a CD or the radio, you can see the current time. To display the clock, press the CLOCK/DISPLAY button on the Unit. To return to the original display, press the same button until the original display appears. Note: You need to set the clock first in order for it to work. (See "Setting the Clock" on page 10.)

Adjusting the Brightness (DIMMER) [RD-T7RGN Only]
When the Unit is operated on AC power, you can adjust the brightness of the display's backlighting.

When the Unit is turned on ����
Each time you press the SNOOZE/DIMMER button on the Unit, the backlight fully turns on or dims.

When the Unit is turned off (Standby) �
Each time you press the SNOOZE/DIMMER button on the Unit, the backlight dims or turns off. When the Unit is operated on batteries, you can turn on or off the backlighting of the display.

When the Unit is turned on ����
Each time you press the SNOOZE/DIMMER button on the Unit, the backlight turns on or off.

4