SONY RCD-W2000ES
Manual de Servicio

RCD-W2000ES

4.

CDM65-RBD2 Electrical Adjustment

4-1. Laser Power Adjustment 1) 2) Start up the TeraTermPro and set the switch S510 on the jig to �CONTROL�. Select the menu as follows. Control � Macro, and select 01ldp_S.ttl. Press �Open�. (Fig. 4-1)

4 Fig. 4-1

3) 4) 5)

Press the �RESET� button (SW101) of the jig as prompted by the display. Press the �RESET� button (SW101) of the jig again as prompted by the display. When the display as shown in Fig. 4-2 appears, type the serial number (see Fig. 4-3) that is printed on the label attached to the RBD2. (This dialog appears only when the EEPROM IC502 is replaced.)

4 Fig. 4-2

4 Fig. 4-3

When the display as shown in Fig. 4-4 appears, press �No�.

4 Fig. 4-4

When the display as shown in Fig. 4-5 appears after that, press �Yes�.

4 Fig. 4-5

38