Recording to a Cassette Tape
Before recording: q When recording important selections, make a preliminary test to ensure that the desired material is properly recorded. q SHARP is not liable for damage or loss of your recording arising from malfunction of this unit. q The ALC (Automatic Record Level Control) circuit automatically controls the level of the input signal used for recording. q The VOLUME and X-BASS controls may be adjusted with no effect on the recorded signal. (Variable Sound Monitor) q Metal and CrO2 tapes cannot be used for recording.
s Recording from a CD
1 Set the FUNCTION switch to CD. 2 Load the disc to be recorded. 3 Load a blank cassette into the cassette compartment with the side to be recorded on facing toward you. 4 Press the RECORD q button. 5 Press the PLAY/PAUSE 0 6 button on the CD.
To stop recording: Press the STOP/EJECT s 7 button. If the STOP s or PLAY/PAUSE 0 6 button is pressed whilst recording, or if the CD comes to its end, the tape deck will not stop. To record a specific track: Press the REVIEW/DOWN 5 or CUE/UP 4 button until the desired track number is displayed, then start recording.
s Recording from the radio
1 Set the FUNCTION switch to FM or AM. 2 Tune in to the station to be recorded. 3 Load a blank cassette into the cassette compartment with the side to be recorded on facing toward you. 4 Press the PAUSE 6 button. 5 Press the RECORD q button.
q If a whistling noise occurs when recording from an AM station, set the
6 Press the PAUSE 6 button again.
To stop recording: Press the STOP/EJECT s 7 button.
BEAT CANCEL switch (on the bottom of the unit) to A or B, whichever gives the best reception.
s Erasing a recorded tape
1 Set the FUNCTION switch to TAPE. 2 Load a tape into the cassette compartment with the side to be erased facing toward you. 3 Press the RECORD q button.
E-7