PANASONIC PV-GS19PC
Manual de Servicio

PV-GS19P / PV-GS31P / PV-GS32P / PV-GS35P / PV-GS19PC / PV-GS31PC / PV-GS34PC / PV-GS35PC

13. Installation of LCD Panel, Reflect Sheet, Lead Light Panel, Diffusion Sheet, BEF Sheet, BEF Sheet A, Panel Holder Unit a. When replacing the LCD Panel, the Diffusion Sheet, the BEF Sheet and the BEF Sheet A, make sure to remove the Protection Sheets. To distinguish Sheets from attached Protection Sheet: - A blue Protection Sheet is affixed to both faces of the Diffusion Sheet. - A yellow Protection Sheet is affixed to both faces of the BEF Sheet. - A transparent Protection Sheet is affixed to both faces of the BEF Sheet A.
Protection Sheet (blue) Diffusion Sheet

Reflect Sheet Lead Light Panel

adhesive tape

Diffusion Sheet (white)

Protection Sheet (yellow)

BEF Sheet

BEF Sheet (stripe) BEF Sheet A

Protection Sheet (green)

BEF Sheet A

(gray) slot slot hole adhesive tape hole cross mark LCD Panel cross mark

(L-5) Panel Holder Unit b. Use extreme care when handling the LCD Panel, the Reflect Sheet, the Lead Light Panel, the Diffusion Sheet, the BEF Sheet and the BEF Sheet A to avoid damage, dust, and spots (especially fingerprints, etc.) Install in order shown below. 1) Install in order the BEF Sheet A, BEF Sheet and Diffusion Sheet while inserting the corners of each sheets into the slots of the Panel Holder Unit. 2) Install the Lead Light Panel while inserting the corners into the slots of the Panel Holder Unit. 3) Align the Reflect Sheet with the edge of the Panel Holder Unit, and install it using adhesive tape on the Reflect Sheet. View A

adhesive tape

cross mark cross mark
Reflect Sheet adhesive tape

hole of Panel Holder Unit

View A Fig. D13-2

hole of Panel Holder Unit

Panel Holder Unit

Do not touch the surface of Lead Light Panel.

Fig. D13-1 4) Install the LCD Panel with adhesive tape so that the cross marks are positioned in the center of the holes in the Panel Holder Unit.

41