PANASONIC PTD9610U
Manual de Usuario

Adjusting the picture to the desired setting (continued)
Adjusting the white balance (High / Low)
Adjustment procedure (Project a signal to be adjusted)
MENU AUTO SETUP LENS PICTURE POSITION OPTION SIGNAL LIST TEST PATTERN

Press the MENU button. ... The MENU screen will be displayed. Press the UP ( ) and DOWN ( ) arrow buttons to select PICTURE.

SELECT : ADJUST : ENTER EXIT : MENU

PICTURE COLOR TEMP BRIGHT CONTRAST COLOR TINT SHARPNESS H SHARPNESS V NR GAMMA MODE :� � �� : nnn : nnn : nnn : nnn : nnn : nnn : ��� �� : 2.2

Press the ENTER button. ... The PICTURE screen will be displayed. Press the UP ( ) and DOWN ( ) arrow buttons to select COLOR TEMP. ) arrow buttons to select the desired setting

Press the LEFT ( ) and RIGHT ( from those indicated below.

SELECT ADJUST SUB MENU EXIT

: : : ENTER : MENU

LOW, MID, HIGH, USER, DYNAMIC

WHITE BALANCE R : 33 G : 120 B : MIN

�If you would like to further adjust the white balance� Select USER in step . Press the ENTER button. ... �The WHITE BALANCE HIGH (LOW) screen will be displayed. Press the ENTER key to switch between WHITE BALANCE HIGH and WHITE BALANCE LOW. Press the UP ( ) and DOWN ( ) arrow buttons to select either R, G or B.

SELECT : ADJUST : + � EXIT : MENU

120 � � � � � � ������

Use the control level buttons ( + and � ) to adjust the setting level. Adjustment Item R (Red) G (Green) B (Blue) Operation Press the [+] button. Press the [�] button. Press the [+] button. Press the [�] button. Press the [+] button. Press the [�] button. Adjustment Details The red component becomes stronger. The red component becomes weaker. The green component becomes stronger. The green component becomes weaker. The blue component becomes stronger. The blue component becomes weaker. Max. value 255 Min. value 0�� Adjustment Range

NOTE

� If these adjustments are not made correctly, none of the colors will be reproduced correctly. � If you make an error in adjustment so that the colors do not match correctly, press the STD button while one of the individual adjustment screens is being displayed. Only the item being displayed will be reset to the factory pre-settings. � The projection of a built-in test pattern (Refer to page 65.) does not allow the white balance adjustment. Be sure to project an external input signal for this adjustment.

56