PIONEER PRV-LX10/WYV/RB
Manual de Servicio

5

6

7

8

How to replace the fan in the ATX Power Supply unit Removing the fan
1 Remove the switch-barrier fixing screw on the ATX Power Supply unit (DXF1005) then slide the switch barrier, as indicated in the figure. Note: Be sure to set the POWER switch to OFF and disconnect the AC power cord from the AC outlet before starting this step.
Switch-barrier fixing screw Switch barrier
B

ATX Power Supply Unit (DXF1005)

A

2 Remove the fan guard, then remove the fan and disconnect the harness from the fan connector.

Fan connector Fan Cleaning Remove the fan. Cleaning paper : GED-008
C

Attaching the fan
1 Connect the harness to the fan connector and install the fan into the panel. Push the harness inside.
Notes: � Place the fan so that the name plate of the fan can be seen from the front. � Use the Fan Unit (DZM1001) dedicated to the ATX Power Supply unit (DXF1005).

Fan Cleaning Cleaning paper : GED-008

Push the harness inside so that it will not come out. Name plate can be seen.
D

Hook the slots.

2 Attach the fan guard.

Close.

E

3 Slide the switch barrier and tighten the screw.

1. Slide

2. Tighten the screw.

F

PRV-LX10
5 6 7 8

167