PIONEER PRO-520HD/KUXC/CA
Manual de Usuario

FRONT PANEL FUNCTIONS
A flip-down door conceals the INPUT 4 jacks. Push gently and release, to open the door. To close the door, lift it back up into place.
NOTE: If you accidentally pull the door, it may not shut properly. Push the door back in to shut it.

1 POWER STANDBY/ON indicators
red: STANDBY green: ON

2 ROOM LIGHT SENSOR (RLS)
Sensor to detect the room brightness.

3 MAIN POWER

(OFF/ON) button

If the button is OFF, the power of the monitor is shut off and 4 STANDBY/ON button on the receiver or TV power on the remote control will not function. Pressing the button again will turn the monitor ON and the monitor enters the standby mode. In the standby mode, you can turn on the monitor using the 4 STANDBY/ON button on the monitor or TV power on the remote control.

4 POWER ( STANDBY/ON) button
Switches the monitor between on and standby (note that the monitor consumes a small amount of power (0.3 W) in standby mode.

5 INPUT SELECT button
Press to select your program source. Each press of the INPUT SELECT button changes the selection to the next source. TV INPUT 4 INPUT 3 INPUT 1 INPUT 2

While the menu is displayed, it performs the same operation as the SET/ENTER button on the remote control.

6 CHANNEL buttons
Press plus (+) or minus (�) to tune to a higher or lower channel. Only the preset channels can be tuned in using these buttons. In some cases, the door may only open slightly when pushed. In such cases, open the door with your finger as shown in the figure at left.
PUSH

1

2

3

4

5

6

7

MAIN POWER
STANDBY/ON SELECT

STANDBY ON
ROOM LIGHT SENSOR POWER INPUT CHANNEL RETURN

20