SONY PLMA55
Manual de Usuario

[Preparation for Preset Data Writing, Battery Down Adjustment, and Charge Threshold Level Adjustment] 1 �Preset Data Writing�, �Battery Down Adjustment�, �Charge Threshold Level Adjustment� and all adjustments of �Video Block� must be performed, if IC901 (EEPROM) on the YM-11 was replaced. 2 �Battery Down Adjustment� and �Charge Threshold Level Adjustment� must be performed, if IC902 (5 V REG.) or IC903 (microprocessor) on the YM-11 was replaced. 3 All adjustments of �Video Block� must be performed, if IC101 (OSD), IC103 (Y/C separation), IC201 (Y/R-Y/B-Y decoder) on the YM-11 board, or IC401 (LCD driver) on the RG-46 board, or LCD (optical block) was replaced. 1. Service Jigs (1) Adjusting remote commander (RM-95-modified)
Note 1: J-6082-053-B

Adjusting Remote Commander RM-95 (J-6082-053-B)

NORMAL/SERVICE mode selection

HOLD

START/ STOP

WIDE

ZOOM

TELE REC REVIEW

Page change

FOCUS POWER AUTO/MAN

(2)

Extension cable (for remote commander plug converter) J-6082-291-A

Note 1: The page will not be changed over, unless the microprocessor in the adjusting remote commander is a new one (UPD7503-G-C5612). In such a case, replace with new microprocessor (8-759-14835).

EDIT SEARCH

2. Adjusting Remote Commander For the adjustment, the adjustment data saved in the nonvolatile memory (EEPROM) must be rewritten, and for this purpose the adjusting remote commander is used. The adjusting remote commander makes two-way communication with the product using a remote control signal line (LANC). The adjusting remote commander transmits pages, addresses, and data up/down commands to the product. The product transmits pages, addresses, and data to the adjusting remote commander.

COUNTER RESET DISPLAY FRAME

SLOW

Data writing

Data change

REC

PAUSE

REW

PB

FF

Address change

RM-95 STOP

3. How to Use Adjusting Remote Commander (1) Connect the adjusting remote commander to the CN902 on YM11 board via extension cable (J-6082-291A). At this time, set the switch of extension cable to OFF (OPEN) position. Turn ON the power on the set. (2) Set the HOLD switch on the adjusting remote commander to the HOLD (SERVICE) position. If connection is normal, the LCD display on the adjusting remote commander will be as shown in Fig.3-2.

(

)

Fig. 3-3

Page

Data

Address

Fig. 3-2

� 19 �