HITACHI PJ5502
Manual de Servicio

SERVICE MENU
To display the OSD for �SERVICE MENU� set up.
������� ��������������������� �������� ������� ������������ �������� ���� ���������� �����������
������������� �� ���������������

By the control panel 1. Display the menu by the �MENU� button. 2. Select the �OPT.� on the menu. 3. Continue press the button � � first, then press the button � � together with �RESET�, and hold for 3 seconds.

By the remote control transmitter 1. Display the menu by the �MENU� button. 2. Select the �OPT.� on the menu. 3. Continue pressing the button �MAGNIFY OFF� for 3 seconds.

Setup of a Cooling Fan Speed
When using this projector in the place where altitude is high, we recommend you to set a cooling fan�s speed as �HIGH�. It is because the cooling efficiency of a projector falls and the temperature inside a projector rises easily in such a place, since the density of air becomes low.

Setting Method of Cooling Fan Speed
1. Select the �FAN SPEED� on the OSD using button � � by the SERVICE MENU.
���������������������� ������������������������

��������

������

����

���������������������

2. Select the �HIGH� on the OSD using the button � �. To reset this setup, select the �NORMAL� using the button � �. 3. The OSD will be ended by no operation for 10 seconds or change of input signal. To end immediately, use one of buttons except buttons � �, � �, � �, � �.

NOTE:
The �HIGH� mode makes the fan noisy than �NORMAL� mode. The recall of factory setting sets the fan speed to �NORMAL� mode. You must set the fan speed after recall of factory setting if you need �HIGH� mode.

28