|
|
|
Usuarios conectados
Actualmente hay 5641 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
English 2. Screw an supplied screw into the speaker mounting hole (lower of the two) at the top, rear of the �at screen TV.
Do not tighten it all the way yet. Leave it loose, with about 5 mm left to tighten.
4. Adjust the position of the speaker and then tighten the upper and lower screws �rmly. 5. Tighten the two screws, at the top and bottom for each speaker (total of four screws), thus �xing the speakers to the �at screen TV.
�������� ��������� ����
������������� ��������������
��������������������� ����
���������������������������
3. Hang the speaker bracket on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the lower screw temporarily.
After passing the wide part of the hole of the speaker bracket (top) over the screw, lower the speaker onto it.
6. Pass the supplied speaker cable between the speaker and the �at screen TV (below the speaker bracket) from below. 7. Connect the speaker cables to the speaker (see next page). 8. Insert the cable in the groove on the speaker.
������������� ���������������� ������������� ������
������������������ ����������������� ��������������������� ������������������
�������������������������� ������������������������� ��������������������������� �������������������������� ��������
9. Connect the other end of the speaker cables to the rear of �at screen TV (see next page).
4
|
|
|
> |
|
