PIONEER PDP-434CMX-43MXE1S]
Manual de Servicio

5

6

7

8

3 X CONNECTOR A Assy, B Assy, 43 SCAN A Assy and B Assy
X CONNECTOR A and B Assy
Remove the one screw. Note: Be sure to remove this screw. If you don't, the connector on the LED OPT Assy may be damaged.
A

1 2 3 4

Remove the one nylon rivet.

6

6

43 X DRIVE Assy

6

Remove the LED OPT Assy.

6 5

Front chassis VR (43M) Flat clamp

6
Bottom view

Remove the enclosure sheet 1. Note: Enclosure sheet 1 is attached to comply with the safety standards. Make sure that it will not be shifted or peeled off. If it is peeled off, securely reattach it in its original place.

1

2
B

5 6

Remove the jumper wire by removing the flat clamp. Remove the front chassis VR (43M) by removing the five screws.

4
Enclosure sheet 1

3

LED OPT Assy

7 8

Remove the six screws. Remove the X CONNECTOR A and B Assy.

43 X DRIVE Assy

7

�2

7

�4

C

Note when reassembling the front chassis VR (43M) Remove or loosen the screws that secure the panel holder in order not to damage the front protect panel Assy.

8
X CONNECTOR B Assy

8
X CONNECTOR A Assy

43 SCAN A and B Assy

1 2 3 4

Remove the one nylon rivet. Remove the jumper wire by removing the flat clamp. Remove the one screw. Remove the front chassis VL (43M) by removing the five screws.

4

4

43 Y DRIVE Assy

4
D

4

Front chassis VL (43M)

Flat clamp

4 2

3

1
E

5 6 7 8 9

Remove the four screws. Disconnect the two pin connectors. Remove the two spacers. Remove the four spacers. Remove the 43 SCAN A and B Assy. 43 Y DRIVE Assy

5 6 8 9

�2

5 8 8 7

�2

6 7 8 9
43 SCAN A Assy
F

Note when reassembling the front chassis VL (43M) Remove or loosen the screws that secure the panel holder in order not to damage the front protect panel Assy.

43 SCAN B Assy

PDP-434CMX
5 6 7 8

113