PIONEER PDA5001
Manual de Usuario

PDA-5001

7. GENERAL INFORMATION
7.1 CONNECTION AND DISASSEMBLY
Connecting this unit to the display
This unit is to be used only when connected to the plasma display, PDP-502MXE.

3 Separate the two connector cables from the cover.

Before connecting this unit to the display, please be sure to do the following:
÷ Undo any component or personal computer connections that may have already been made to the plasma display. ÷ Make sure that the power of the plasma display is turned off, and is unplugged from the wall outlet.

Precautions when connecting this unit to the display
When the covers on this unit and/or the display are opened to make connections, be sure to avoid letting the screw rivets or their respective parts fall into openings on the units. CAUTION This unit is designed only for connection to the plasma display, PDP-502MXE. Do not alter or modify this unit in any way as it may cause this unit to perform abnormally and/or may cause the plasma display to malfunction.

4 Pull the two connector cables through the slot on the connector
cover included with this unit.

Connector Cover (Included with this unit)

To connect this unit to the plasma display PDP- 502MXE

1 Remove the cover plate on the back panel of the plasma display.
Unscrew using a philips screwdriver (�+� head).

5 Secure the connector cover onto the display with 2 of the
Note: If for some reason the screws cannot be unscrewed, use a tool or other object with a tip flat enough to fit between the screw and rivet and pry the screw out as shown below. included screw rivets.

Screw Rivet

Connector Cover (PDP-502MXE side)

2 Remove the cover plate on the back panel of the plasma display.
The two cable connectors are attached to the inside of the cover plate.
J123 8P Wire Assy (ADX2554) J122 13P Wire Assy (ADX2553)

24