SHARP PCA800
Manual de Usuario

Changing a Battery Pack
The procedure to remove and install a battery pack is as follows: 1. 2. 3. Turn off the computer, close the upper cover and turn the computer over and lay on a soft surface. On the left side of the computer, locate the battery lock button. On the base of the computer, locate the pressure point embossed on the base of the battery pack for pushing it out of the battery compartment.
Raised ribs to push battery pack

3

Battery pack

Battery lock button

4. 5. 6.

7.

Press and hold down the battery lock button and push on the raise ribs to slide out the battery pack. You can release the battery lock button once the battery pack is partially removed. After the battery pack is completely removed, hold the replacement battery in a horizontal position level with the battery compartment and slide it into place. Guide rails on either side of the compartment, and grooves on the battery pack guide the battery pack into place. Push the battery all the way in so that you feel the battery pack engage with the connector inside the compartment and the battery lock in place.

3-5